11
6 • HP DESKJET 3050 ALL-IN-ONE J610 SERIES
Windows: Install software
•If you have a Wi-Fi Protected Setup (WPS) router with a push button, press the button
on the router now. The blue wireless light on the printer will turn on when the printer
is connected. Then continue with the steps below.
•If you are not certain your router has this feature, or the blue wireless light on the
printer does not turn on, continue with the steps below.
1
Insert the software CD, and then follow the onscreen instructions.
Important! Do not connect the USB cable unless prompted during the software install. Not all
installations will require using a USB cable.
2
When you reach the Connection Type screen, select Network or USB.
•Select Network if you want to connect your printer using a wireless connection.
Note: You may be asked to press the wireless button on the printer, and then read the printer
display. If you do not see an IP address (a series of numbers such as 192.168.0.3) on the printer
display, select “I see a status such as Not Connected or Wireless Disabled (or I am not sure)”
when asked by the software.
•Select USB if you want to directly connect your printer to your computer with a USB cable.
3
Continue following onscreen instructions to complete the setup.
Windows: 安装软件
•
如果您的 Wi-Fi 保护设置(WPS)路由器有“push”按钮，请立即在路由器上按下该按
钮。连接打印机时，打印机上的蓝色无线指示灯将亮起。然后继续执行以下步骤
。
• 如果不能确定路由器是否具有该功能，或者打印机上的蓝色无线指示灯未亮起，请
继续执行以下步骤。
进入连接类型屏幕时，请选择网络或 USB。
• 如果要使用无线连接方式连接打印机，请选择网络。
注意：可能要求您按下打印机上的无线按钮，然后阅读打印机显示的内容。如果您没有在打印
机显示器上看到 IP 地址（一串数字，例如 192.168.0.3），请在软件要求您时选择“我看到诸
如“未连接”或“已禁用无线”的状态（或者我不确定）”。
• 如果要使用 USB 连接线将打印机连接到计算机，请选择 USB。
2
继续按照屏幕上的说明完成安装操作。
3
插入软件 CD，然后按照屏幕上的说明进行操作。
重要提示！软件安装期间，请勿在没有提示的情况下连接 USB 连接线。并非所有安装都需要使用
USB 连接线。
1
ZHCN
EN
To Next Page
Loading...