HP J9727A

xxx.xxx.xxx.xxx |std | 3min 2sec | all
xxx.xxx.xxx.xxx |filt| 23min 3sec | A1-B3, C4
xxx.xxx.xxx.xxx |filt| 23min 10sec| A1,B2,C5
xxx.xxx.xxx.xxx |filt| 2min 5sec | F22
VLAN ID: 200
VLAN Name: client vlan
IGMP Version: 2
Querier Address: 10.0.102.204
Querier Port: 4 <only displayed when not querier>
Querier Up Time: 1hr 53min 2sec
Querier Expiry Time: 2min 1sec
Ports with multicast routers: A1, A3-A5
Active Group Addresses |Type| Expires | Ports
----------------------------+----+--------------------------------
xxx.xxx.xxx.xxx |filt| 1min 2sec | A1
xxx.xxx.xxx.xxx |std | 3min 2sec | all
xxx.xxx.xxx.xxx |filt| 23min 3sec | A1-B3, C4
xxx.xxx.xxx.xxx |stat| 0min 0sec | A1,B2,C5
xxx.xxx.xxx.xxx |filt| 2min 5sec | F22
show ip igmp vlan 200
IGMP Service Protocol Info
Total VLAN’s with IGMP enabled: 33
Current count of Multicast groups joined: 21
VLAN ID: 200
VLAN Name: client vlan
IGMP Version: 2
Querier Address: 10.0.102.204
Querier Port: 4 <only displayed when not querier>
Querier Up Time: 1hr 53min 2sec
Querier Expiry Time: 2min 1sec
Ports with multicast routers: A1, A3-A5
Active Group Addresses |Type| Expires | Ports
----------------------------+----+--------------------------------
xxx.xxx.xxx.xxx |filt| 1min 2sec | A1
xxx.xxx.xxx.xxx |std | 3min 2sec | all
xxx.xxx.xxx.xxx |filt| 23min 3sec | A1-B3, C4
xxx.xxx.xxx.xxx |stat| 0min 0sec | A1,B2,C5
xxx.xxx.xxx.xxx |filt| 2min 5sec | F22
Syntax:
show ip igmp config
Global command listing IGMP status for all VLANs configured in the switch.
IGMP Service Config
Control unknown multicast [Yes]: Yes
Forced fast leave timeout [0]: 0
Delayed flush timeout [0]: 0
VLAN ID|VLAN NAME |IGMP Enabled|Querier Allowed | Querier Interval |
-------+--------------------------------+-----------+----------------------
1 |DEFAULT_VLAN |No |Yes | 125 |
200 |client vlan |Yes |No | 125 |
300 |Data Centre |Yes |Yes | 125 |
Syntax:
show ip igmp vlan <vlan> config
IGMP V2 NG Overview 29