# Configure an unused port (Ethernet 1/0/5 for example) of Switch A as the reflector port of remote
source mirroring group 1, and disable STP on the port.
[SwitchA] mirroring-group 1 reflector-port Ethernet 1/0/5
[SwitchA] interface Ethernet 1/0/5
[SwitchA-Ethernet1/0/5] undo stp enable
# Create VLAN 10 and assign the three ports (Ethernet 1/0/11 through Ethernet 1/0/13) connecting the
three data monitoring devices to VLAN 10.
[SwitchA] vlan 10
[SwitchA-vlan10] port ethernet 1/0/11 to ethernet 1/0/13
[SwitchA-vlan10] quit
# Configure VLAN 10 as the remote probe VLAN of remote source mirroring group 1.
[SwitchA] mirroring-group 1 remote-probe vlan 10
142
To Next Page
Loading...
