HP JG708A User Manual

7
Installing the switch
The HP 1410 switch can be installed in a 19-inch rack or on a workbench. The installation procedures for
the HP 1410-24-R switch and the HP 1410-24G-R switch are the same. The following installation
procedure uses the HP 1410-24-R switch as an example.
W
ARNING!
Before installing or moving the switch, remove the power cord.
Mounting the switch in a 19-inch rack with
mounting brackets
To install the switch with mounting brackets:
1. Wear an ESD-preventive wrist strap, and make sure the rack is securely grounded and is stable.
2. Attach the mounting brackets on the sides of the front panel with screws.
Figure 1 Installing the mounting brackets to the HP 1410-24-R switch
3. Place the switch on a holder in the rack, and push in the switch along the guide rails until the oval
holes in the brackets align with the mounting holes in the rack posts.
4. Attach the mounting brackets to the rack posts with screws.

HP JG708A Specifications

General

Brand	HP
Model	JG708A
Category	Switch
Language	English