EasyManuals Logo

HP Kayak XU800 Troubleshooting Guide

HP Kayak XU800
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
11
Your PC Workstation Does Not Start Correctly
Case 2 — Monitor Is Blank
Case 2 — Monitor Is Blank
When the power button is pressed, the PC Workstation appears to
boot (sound from the hard disk drive and fan, and status LED is
green), but the monitor is blank.
Hard disk drive and fan can be heard.
Status LED is GREEN.
MaxiLife status panel displays a smiling face .
Press the power-off button and keep it pressed for about five seconds.
The PC Workstation will turn off.
NOTE Before removing the cover, always switch off the display and PC Workstation.
Disconnect the power cord and any accessory cables. When checks have been
completed, close the PC Workstation and reconnect the power cord and accessory
cables. Verify that the PC Workstation boots correctly.
HP KAYAK XU800
INFO
SERVICES
Symptom... Check that... How...
Power indicator light and hard
disk activity light work but the
screen remains blank.
The display is switched ON (LED is on). Refer to the monitor manual for an explanation of the LEDs.
The monitor’s power cord is correctly
connected.
Ensure the power cord is plugged into a grounded power outlet
and into the monitor.
The monitor’s power outlet is working. Plug a light into the grounded power outlet and check that it
comes on.
If the monitor is still blank
Check that... How...
The monitor’s brightness and contrast
settings are correct.
Refer to the monitor manual if necessary.
The monitor itself is not faulty. 1 Replace the monitor by a known working monitor from the
same model of PC Workstation.
2 If the monitor starts, contact HP Support or your authorized
dealer. The monitor may need to be replaced.
The video cable pins are not damaged. 1 Switch off and unplug the monitor.
2 Disconnect the video cable and straighten any bent pins.
3 Reconnect the video cable.
4 Switch on the monitor and see if it works.
You may need to update the Basic Input Output System (BIOS). Create a bootable floppy to update the BIOS. Refer to page 36.
Or, if the BIOS is corrupt, refer to page 38 for instructions on
how to recover the BIOS.
Case 2 — Monitor Is Blank is continued on the next page
Yits.bok Page 11 Friday, December 17, 1999 11:33 AM

Other manuals for HP Kayak XU800

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Kayak XU800 and is the answer not in the manual?

HP Kayak XU800 Specifications

General IconGeneral
BrandHP
ModelKayak XU800
CategoryDesktop
LanguageEnglish

Related product manuals