To Next Page

To Previous Page

4–8 www.hp.com User’s Guide

Operating the Monitor

Identifying Special OSD Messages

Special OSD messages appear on the monitor screen when

identifying the following monitor conditions:

■ Input Signal Out of Range—indicates the monitor is unable

to access or fully support the provided input signal. The

monitor’s preferred video mode is 1920 x 1200 - 60Hz.

■ Going to Sleep—Indicates the monitor is entering the sleep

mode.

■ Check Video Cable—Indicates the video cable may not be

plugged into the computer or monitor, or that the computer

may not be turned on.

■ No Input Signal—Indicates the monitor is not receiving a

video signal from the PC. Check to see if the PC is off or in

the power saving mode.

Adjusting Screen Quality

Allow the monitor to warm up for 20 minutes before performing

the following procedures.

The Auto Adjustment feature automatically fine-tunes the image

quality each time a new video mode is utilized. If additional

improvement is desired, select the Auto button on the front bezel.

For more precise adjustments, use the adjustment pattern

provided on the CD-ROM, and adjust the clock and phase

settings (accessed from the OSD menu) as described in the

following section.

Questions and Answers:

Need help?

Do you have a question about the HP L2335 and is the answer not in the manual?

HP L2335 Specifications

General

3D	No
Pixel pitch	0.258 x 0.258 mm
Aspect ratio	16:9
Response time	16 ms
Display diagonal	23 \
Display resolution	1920 x 1200 pixels
Contrast ratio (dynamic)	-
Display number of colors	16.78 million colors
Viewing angle, horizontal	170 °
Digital vertical frequency	48 - 85 Hz
Digital horizontal frequency	30 - 94 kHz
Display brightness (typical)	250 cd/m²
Supported graphics resolutions	1152 x 870, 1920 x 1200 (WUXGA)
DVI-D ports quantity	0
LED indicators	Power
Tilt angle range	-5 - 25 °
Height adjustment	90 mm
Cable lock slot type	Kensington
On Screen Display (OSD)	Yes
Panel mounting interface	100 x 100 mm
AC input frequency	50 - 60 Hz
Power consumption (typical)	100 W
Power requirements	90 - 265V
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Certification	ACA, CSA, CE, CCIB/CCEE, CISPR, FCC, TUV/GS, VDT, NOM, MIC, MPR-II, PC2001, PC99, BSMI, TCO, TUV-Ergo, UL, VCCI
Country of origin	China
Sustainability certificates	ENERGY STAR