178 Removal and replacement ENWW
500-sheet feeder separation pad
Note See page 139 for procedures for removing the separation pad from a 250-sheet feeder.
1 Slide the media tray out of the 500-sheet feeder and remove media from the feeder.
2 Press down the lift plate (callout 1)
Note The lift plate on 500-sheet feeders does not lock.
3 Use a flatblade screwdriver to release two tabs (callout 2) on the separation pad.
4 Slide the separation pad straight up and off of the feeder.
Figure 103. Removing the 500-sheet feeder separation pad
2
2
2
1
To Next Page
Loading...