HP LaserJet 3015 - Page 30

Electrical specifications (all models)
Note
The values are subject to change. See http://www.hp.com/support/lj3015 or
http://www.hp.com/support/lj3030 for the most current information. The 110-volt and 220-volt
power sources are not interchangeable.
Table 1-5. Electrical specifications (all models)
Item 110-volt models 220-volt models
Power supply 110 to 127 V (± 10%)
50 to 60 Hz (± 2 Hz)
220 to 240 V (± 10%)
50 to 60 Hz (± 2 Hz)
Power consumption (typical)
Printing
Standby
Power Save
Off
300 W (average)
14 W (average)
14 W (average)
0 W
300 W (average)
14 W (average)
14 W (average)
0 W
Minimum recommended circuit
capacity
4.5 A 2.3 A
Acoustic emissions (all models)
Note
The values are subject to change. See http://www.hp.com/support/lj3015 or
http://www.hp.com/support/lj3030 for the most current information. During other operations,
acoustic emissions can vary.
Table 1-6. Acoustic emissions (all models)
Activity
level
Operator (<1m) Bystander (1m) Sound power
Active LpAm56 dB (A) LpAm48 dB (A) LWAd6.1 Bels dB (A)
Idle inaudible inaudible inaudible
Skew specifications (all models)
Table 1-7. Skew specifications (all models)
Category Specification
Skew: all vertical lines are
parallel to the left edge of the
media.
3.0 mm (0.12 inch) over 250 mm (9.85 inches) length (0.8 percent)
for cut-sheet media (except for A5 size)
3.3 mm (.13 inch) over 220 mm (8.66 inches) length (1.5 percent)
for envelopes, postcards, and A5 size cut-sheet media.
1.65 mm (0.06 inch) over 190 mm (7.48 inches) width for cut-sheet
media (leading-edge skew)
12 Chapter 1 Product Information ENWW