Removal and Replacement
User Installable Assemblies
Memory/Language SIMMS (LaserJet 4P/4MP)
●
The SIMM slots are under an access panel on the left side of the
printer. Place the printer on a firmly supported, flat surface.
1. Push downward forcefully on top of the access panel to release
its clips from the main Printer Cover (Figure 6-3, callout 1).
●
2. Remove any SIMM modules (release side clips, tilt upward and
lift out carefully).
clAL!-l-lo
N
SIMM modules must be removed prior to
removing the Printer Cover to avoid damage.
Figure 6-3
Removing the SH’JM Access
Panel (LaswJet 4P/4NlP)
Tore-install:
SIMM module can be installed in any available slot. Sequence is
irrelevant. Install with the small notch toward the left. To
re-install the access panel, hold it in place and lift firmly upward
on the thumb grip (Figure 6-3, callout 2) to snap into place.
6-5
To Next Page
Loading...