Removal and Replacement
Cover and Doors
Cover and Doors
Power, I/O and Memory Doors (LaserJet 4L/4ML)
●
The Power Door is located on the right side of the printer. The I/O
Door and Memory Door are on the left side (refer to Figure 1-2).
Some doors are not hinged; and are removed simply by opening.
Others (such as the Power Door) have a small hinge tab which
a
holds the door in place. To remove the Power Door:
1. Open the door to a 90 degree angle.
2. Push the upper tab down slightly and tilt the door out
(Figure 6-4).
Figure 6-4 Removing the Power Access Dcmr (LaserJet 4L/4ML)
6-6
To Next Page
Loading...