112 Removing and replacing parts Q1860-90918
Parts removal order
Use the following diagram to determine which parts must be removed before removing other
parts:
Formatter assembly
Dc controller and power supply
Paper-feed belt assembly
Front cover and tray 1
Front cover pins
Tray 1 inner cover
Tray 1 lift plate
Paper guide
Left and right corner covers
Rear door and rear output bin
Dc controller and power supply
Paper-feed belt assembly
Face-down bin full sensor lever
Fuser
Paper-feed belt assembly
Top cover and toner cartridge
Control panel overlay and control panel
Toner cartridge door assembly
Face-down cover
Laser/scanner assembly
Left and right side covers
Accessory interface connector
Dc controller and power supply
Paper-feed belt assembly
Face-down bin full sensor lever
Fan
Main gear assembly
Delivery roller
Main motor
Paper-feed roller assembly
Registration assembly
Upper delivery assembly
Paper-handling PCA
Pickup-gear assembly
Paper-feed roller assembly
Top-of-page sensor
Tray 2 shaft
Registration assembly
Tray 1 shaft
Tray 1 lift plate
Paper guide
Tray 1 pickup solenoid
Power inlet assembly
Toner cartridge guides
Tray 1 inner cover
Transfer roller assembly
Paper-feed belt assembly
Registration assembly
Tray 1 roller
Tray 1 separation pad
Tray 2 pickup roller
Tray 2 separation pad
www.GovTechMedia.com
To Next Page
Loading...
