124 Removing and replacing parts Q1860-90918
Tray 1 inner cover
The Tray 1 inner cover is a plastic tray located at the top front of the printer. See figure 53.
1 Remove the top cover (see page 115), the front cover and Tray 1 (page 120), and the left and
right side covers (page 123).
CAUTION Be sure to locate the paper-sensor flag on the left side of the cover before proceeding to step 3.
The left end (callout 1) rests in a cutout in the left side of the chassis and is easily broken. In
figure 52, the paper-handling PCA is removed to make identification of the left end of the paper
sensor flag easier. The PCA does not have to be removed to remove the Tray 1 inner cover.
Figure 52. Tray 1 inner cover removal (1 of 2, inner cover flag)
2
1
www.GovTechMedia.com
To Next Page
Loading...
