180 Removing and replacing parts Q1860-90918
500-sheet feeder PCAs
1 Remove the feeder assembly from its base frame (see page 174) and place it upside down
on the work surface.
2 Remove the 500-sheet feeder PCA by disconnecting the cables and then removing the two
machine screws (callout 1).
3 Disconnect two cables from the paper-size switch PCA.
4 Remove two washer-head screws (callout 2), and then lift the PCA from the frame.
Figure 119. Gear assembly, 500-sheet feeder PCA, and paper-size switch PCA removal
2
2
1
2
www.GovTechMedia.com
To Next Page
Loading...
