226 Troubleshooting Q1860-90918
Figure 127. Jetdirect configuration page
4 Novell/NetWare This block should state the Novell printer server name to which the printer is
connected. If the node name reads “NPIxxxxxx” (where xxxxxx = the last six
digits of the EIO’s LAN address), the EIO card has not been configured for a
Novell server. This could indicate that the card is operating under another
protocol than Novell. Check with the network administrator to determine
what Node Name might be appropriate.
Table 54. HP Jetdirect configuration page categories (continued)
2
1
4
3
www.GovTechMedia.com
To Next Page
Loading...
