5. Use a flatblade screwdriver to disconnect one connector (callout 6).
Hint It is easier to disconnect the connector with the paper guide removed.
NOTE The connector release is on the left side of the connector. Push the connector
release when disconnecting the connector.
6
Figure 5-135 Removing the high-voltage power supply (4 of 17)
6. At the back of the printer, pull the plastic cover toward you (callout 7) and unhook two springs
(callout 8). Flex the plastic cover by pressing the two sides inward and remove it from the back of
the printer.
Figure 5-136 Removing the high-voltage power supply (5 of 17)
144 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...