7. Remove the registration unit. See Registration unit on page 134.
8. From the back of the printer, unhook the front claw (callout 9) on the left side of the printer.
NOTE This claw is the one closest to you.
Figure 5-137 Removing the high-voltage power supply (6 of 17)
9. Unhook the rear claw (callout 10).
NOTE This claw is the one furthest to you.
Figure 5-138 Removing the high-voltage power supply (7 of 17)
ENWW Printed circuit assemblies (PCAs) 145
To Next Page
Loading...