HP LaserJet 5200 - Page 229

Control panel message Description Recommended action
58.XX ERROR
alternates with
To continue turn off then on
A processor error has occurred. Check the cable connection of the DC
controller (J301) to the low-voltage power
supply (J201).
59.XY ERROR
alternates with
To continue turn off then on
A printer motor error has occurred. Turn the printer off and then on.
NOTE This message might also
appear if the transfer unit is missing
or incorrectly installed. Ensure that
the transfer unit is correctly installed.
62 NO SYSTEM No system was found. Turn the printer off and then on.
64 ERROR
For help press
alternates with
To continue turn off then on
A scan buffer error has occurred. Turn the printer off and then on.
68.X PERMANENT STORAGE FULL
alternates with
To continue press
A non-volatile storage device is full. Press
to clear the message. Printing can
continue, but unexpected behavior could
result.
X Description:
0 Onboard NVRAM
1 Removable disk (flash or hard)
1.
Press
to continue.
2. For 68.0 errors, turn the printer off and
then on.
3. If a 68.0 error persists, contact
HP Support.
4. For 68.1 errors, use the HP Web
Jetadmin software to delete files from
the disk drive.
68.X PERMANENT STORAGE WRITE FAIL
alternates with
To continue press
A non-volatile storage device is full. Press
to clear the message. Printing can
continue, but unexpected behavior could
result.
X Description:
0 Onboard NVRAM
1 Removable disk
Press to continue.
68.X STORAGE ERROR SETTINGS
CHANGED
alternates with
To continue press
A non-volatile storage device is full. Press
to clear the message. Printing can
continue, but unexpected behavior could
result.
X Description:
0 Onboard NVRAM
1 Removable disk
1.
Press
to see step-by-step
information.
2.
To clear the error, press
to exit the
message, and then press
to
continue.
3. If the problem persists, turn the printer
off and then on.
4.
To exit, press
.
79.XXXX ERROR
alternates with
To continue turn off then on
A critical hardware error has occurred. Turn the printer off and then on.
ENWW Control-panel messages 209