HP LaserJet 5200 - Page 230

Control panel message Description Recommended action
8X.YYYY EIO ERROR The EIO accessory card has encountered a
critical error.
Turn the printer off and then on.
8X.YYYY EMBEDDED JETDIRECT
ERROR
The HP Jetdirect embedded print server has
encountered a critical error.
Turn the printer off and then on.
<BINFULL> FULL
alternates with
<Current status message>
The specified output bin is full but is not
needed for the current job. The message
appears after a print job is sent.
Remove the media from the output bin.
Access Denied MENUS LOCKED Because the printer administrator has
enabled the control-panel security
mechanism, you cannot modify control-panel
settings. The message disappears after a few
seconds, and the printer returns to a Ready
or BUSY state.
Contact the printer administrator to change
settings.
ACTION NOT CURRENTLY AVAILABLE
ON TRAY X
alternates with
Tray size cannot be ANY SIZE/ANY
CUSTOM
Duplex registration is not available when the
tray size is configured for ANY SIZE or ANY
CUSTOM.
Change the size setting for the tray.
BAD DUPLEXER CONNECTION
alternates with
To continue turn off then on
The duplexer is not installed correctly. Turn the printer off and then on to continue.
BAD OPTIONAL TRAY CONNECTION The optional tray is not correctly installed. 1.
Press
to see step-by-step
information.
2. Turn the printer off and disconnect all of
the cables.
3. Remove the optional tray and then
reinstall it.
4. Reconnect all of the cables and turn the
printer on.
5. If the message persists, contact HP
support.
6.
Press
to exit.
Cancelling... The printer is in the process of canceling a
job.
No action necessary.
Cannot Duplex Check Rear Bin The printer has detected a non-auto
duplexing size.
Make sure that the media size meets
duplexing requirements.
Card slot <X> not functional
alternates with
<current status message>
The CompactFlash card in slot <X> is not
working correctly.
CompactFlash is not available for the
HP LaserJet 5200L.
1.
Press
to see step-by-step
information.
2. Turn the printer off.
210 Chapter 6 Troubleshooting ENWW