HP LaserJet 5200 - Page 238

Control panel message Description Recommended action
3. Open the print-cartridge door, remove
the print cartridge, and install a new print
cartridge. Close the print-cartridge door.
4.
Press
to exit.
Request accepted please wait The printer has accepted a request to print an
internal page, but the current job must finish
printing before the internal page will print.
No action necessary.
Resend upgrade The firmware upgrade was not successful. Attempt the upgrade again.
Restoring factory settings The printer is restoring factory settings. No action necessary.
Restoring... The printer is restoring settings. No action necessary.
RFU LOAD ERROR An error has occurred during a firmware
upgrade.
Reinstall the firmware.
Setting saved A menu selection has been saved. No action necessary.
SIZE MISMATCH IN TRAY XX
alternates with
Ready
The tray is loaded with a media size that is
different from the size for which the tray is
configured. Printing can continue from other
trays, but not from this one.
1. Make sure that the media guides are
adjusted correctly.
2. In the PAPER HANDLING menu,
configure the tray for the correct size.
Sleep mode on The printer is in the sleep mode. Any button
press or the receipt of data clears the sleep
mode.
No action necessary. The printer
automatically exits sleep mode.
STANDARD TOP BIN FULL
alternates with
Remove all paper from bin
The output bin is full. Printing cannot
continue.
Empty the output bin. Printing resumes
automatically.
To return to ready press STOP The printer is paused and no error messages
are pending.
No action necessary.
TRAY <X> OVERFILLED REMOVE
EXCESS PAPER
The tray is loaded with too much media. 1.
Press
to see step-by-step
information.
2. Remove excess media.
3.
Press
to exit.
Tray X <TYPE> <SIZE>
alternates with
To change size or type press
The printer is reporting the current
configuration of tray X.
No action necessary.
Press
to clear the message.
Press
to change the type or size.
TRAY XX EMPTY <TYPE> <SIZE>
alternates with
<current status message>
The tray is empty, but the current print job
does not require this tray.
Fill the tray. The message indicates the type
and size of media for the tray.
TRAY XX OPEN
For help press
alternates with
The tray is open, but printing can continue. Close the tray.
218 Chapter 6 Troubleshooting ENWW