SR7 Face-up cover sensor
SL1 Cassette pickup solenoid
SL2 Multipurpose pickup solenoid
SW1 Cassette paper-size detection switch
Jam recovery
Use this option to configure the printer response to jams, including how the printer handles the pages
involved. AUTO is the default value.
●
AUTO: The printer automatically turns jam recovery on when sufficient memory is available.
●
ON: The printer reprints any page that is involved in a jam. Additional memory is allocated to store
the last few pages that were printed, and this might cause overall printer performance to suffer.
●
OFF: The printer does not reprint any page that was involved in a jam. Because no memory is used
to store the most recent pages, overall printer performance might be optimized.
To set the jam-recovery response
1. Press Menu.
2. Press
to highlight CONFIGURE DEVICE, and then press .
3. Press to highlight SYSTEM SETUP, and then press .
4. Press
to highlight JAM RECOVERY, and then press .
5. Press
or to select the appropriate setting, and then press .
6. Press Menu to exit the menu.
ENWW Jam locations 229
To Next Page
Loading...