HP LaserJet 5200

1
2
Figure 2-5 Connecting the USB cable
1 USB port
2 USB connector
Network configuration
NOTE Network configuration is not available for the HP LaserJet 5200L.
You might need to configure certain network parameters on the printer. You can configure these
parameters from the printer control panel, the embedded Web server, or for most networks, from the
HP Web Jetadmin software.
NOTE For more information about using the embedded Web server, see Using the embedded
Web server on page 280.
For a complete list of supported networks and for instructions on configuring network parameters from
software, see the HP Jetdirect Embedded Print Server Administrator’s Guide. The guide comes with
printers in which an HP Jetdirect embedded print server is installed.
Manually configuring TCP/IP parameters from the control panel
Use manual configuration to set an IP address, subnet mask, and default gateway.
Setting an IP address
1. Press Menu.
2. Press
to highlight CONFIGURE DEVICE, and then press .
3. Press
to highlight I/O, and then press .
4. Press
to highlight EMBEDDED JETDIRECT, and then press .
5. Press
to highlight TCP/IP, and then press .
6. Press
to highlight MANUAL SETTINGS, and then press .
7. Press
to highlight IP Address:, and then press .
8. Press the
or arrow to increase or decrease the number for the first byte of the IP address.
24 Chapter 2 Installation and configuration ENWW