9. Press to move to the next set of numbers. (Press to move to the previous set of numbers.)
NOTE To cycle through the numbers more quickly, hold down the arrow button.
10. Repeat steps 8 and 9 until the correct IP address is complete, and then press to save the setting.
11. Press Menu to return to the Ready state.
Setting the subnet mask
1. Press Menu.
2. Press
to highlight CONFIGURE DEVICE, and then press .
3. Press
to highlight I/O, and then press .
4. Press
to highlight EMBEDDED JETDIRECT, and then press .
5. Press
to highlight TCP/IP, and then press .
6. Press
to highlight MANUAL SETTINGS, and then press .
7. Press
to highlight SUBNET MASK, and then press .
8. Press the
or arrow to increase or decrease the number for the first byte of the subnet mask.
9. Press
to move to the next set of numbers. (Press to move to the previous set of numbers.)
10. Repeat steps 8 and 9 until the correct subnet mask is complete, and then press
to save the
subnet mask.
11. Press Menu to return to the Ready state.
Setting the default gateway
1. Press Menu.
2. Press
to highlight CONFIGURE DEVICE, and then press .
3. Press
to highlight I/O, and then press .
4. Press
to highlight EMBEDDED JETDIRECT, and then press .
5. Press
to highlight TCP/IP, and then press .
6. Press
to highlight MANUAL SETTINGS, and then press .
7. Press
to highlight DEFAULT GATEWAY, and then press .
8. Press the
or arrow to increase or decrease the number for the first byte of the default
gateway.
9. Press
to move to the next set of numbers. (Press to move to the previous set of numbers.)
10. Repeat steps 8 and 9 until the correct default gateway is complete, and then press
to save the
default gateway.
11. Press Menu to return to the Ready state.
ENWW Input/Output (I/O) configuration 25
To Next Page
Loading...