To disable DLC/LLC
NOTE Do not disable this protocol when using systems that print to the printer using DLC/LLC.
1. Press Menu.
2. Press
to highlight CONFIGURE DEVICE, and then press .
3. Press
to highlight I/O, and then press .
4. Press
to highlight EMBEDDED JETDIRECT, and then press .
5. Press
to highlight DLC/LLC, and then press .
6. Press
or to select the desired option.
7. Press
to set the selected option.
8. Press Menu to return to the Ready state.
Enhanced I/O (EIO) configuration
NOTE EIO configuration is not available for the HP LaserJet 5200L.
NOTE If you are adding a print server to the base model, additional printer memory might be
required (minimum of 64 MB).
The enhanced input/output (EIO) slot holds compatible accessory devices, such as the HP Jetdirect
print server network cards or other devices. Plugging an EIO network card into the slot increases the
number of network interfaces available to the printer.
HP Jetdirect EIO print servers
HP Jetdirect print servers (network cards) can be installed in EIO slots. These cards support multiple
network protocols and operating systems. HP Jetdirect print servers facilitate network management by
allowing you to connect a printer directly to your network at any location. HP Jetdirect print servers also
support the Simple Network Management Protocol (SNMP), which provides network managers with
remote printer management and troubleshooting through the HP Web Jetadmin software.
NOTE Configure the card either through the control panel, the printer installation software, or
with HP Web Jetadmin software. See the HP Jetdirect print server documentation for more
information.
Connecting to a network or a computer
To connect to a network
1. Connect the network cable to the printer.
2. Find the IP address. On the control panel, press Menu. Select INFORMATION, and then select
PRINT CONFIGURATION. The IP address is on the embedded Jetdirect page, under “TCP/IP”.
NOTE You might need to assign an IP address depending on the type of network that is
installed.
ENWW Input/Output (I/O) configuration 27
To Next Page
Loading...