Cleaning the printer
During the printing process, paper, toner, and dust particles can accumulate inside the printer. Over
time, this buildup can cause print-quality problems, such as toner specks or smearing (see
Troubleshooting print-quality problems on page 238). This printer has a cleaning mode that can correct
and prevent these types of problems.
Figure 3-1 Cleaning the printer
1. Fuser unit inlet guide: Wipe with a lint-free cloth.
2. Transfer charging roller: Do not touch or clean the transfer charging roller it is absolutely
necessary. If you must clean the transfer charging roller, clean it with a dry-lint free cloth. Do not
touch the roller and do not use water or solvent to clean it.
3. Registration roller: Wipe with a lint-free cloth.
4. Tray 1 pickup roller: Wipe with a lint-free cloth.
5. Tray 1 separation pad: Wipe the rubber part with a lint-free cloth.
6. Tray 2 separation pad: Wipe the rubber part with a lint-free cloth.
7. Paper-feeder separation roller: Wipe with a lint-free cloth.
8. Paper-feeder feed roller: Wipe with a lint-free cloth.
48 Chapter 3 Maintenance ENWW
To Next Page
Loading...