9. Paper-feeder pickup roller: Wipe with a lint-free cloth.
10. Tray 2 pickup roller: Wipe with a lint-free cloth.
11. Duplexer feed rollers: Wipe with a lint-free cloth.
Cleaning the printer manually
Clean the outer surfaces with an HP Toner Cleaning Cloth or a water-dampened cloth.
WARNING! Before you begin these steps, turn the printer off and unplug all power cords to
avoid shock hazard. Be careful when cleaning around the fuser area. It might be hot.
CAUTION To avoid permanent damage to the print cartridge, do not use ammonia-based
cleaners on or around the printer. If toner gets on your clothes, wipe it off with a dry cloth and
wash your clothes in cold water. Hot water sets toner into fabric.
Component Cleaning Method
Outer covers Use an HP Toner Cleaning Cloth (part number 5090-3379) or
a water-dampened cloth. Do not use solvents or ammonia-
based cleaners.
Inside, general With a dry, lint-free cloth, wipe any dust, spilled toner, and
paper particles from the paper path area, the registration roller,
and the print-cartridge cavity.
Paper-pickup rollers Clean with lint-free paper. If dirt cannot be removed, dampen
the paper with alcohol.
Cleaning the paper path using the printer control panel
1. Press Menu.
2. Press
to highlight CONFIGURE DEVICE, and then press .
3. Press to highlight PRINT QUALITY, and then press .
NOTE If your printer has an automatic duplexer, go to step 7.
4. Press to highlight CREATE CLEANING PAGE, and then press .
5. Remove all paper from tray 1.
6. Remove the cleaning page and load it face-down in tray 1.
NOTE If you are not in the menus, navigate to PRINT QUALITY by using the previous
instructions.
7. At the printer control panel, press to highlight PROCESS CLEANING PAGE, and then
press
.
ENWW Cleaning the printer 49
To Next Page
Loading...