Exit Roller Assembly
1 Remove Printer Covers.
2 Grasp both tabs at the lower ends of the Exit Roller bushings and pull inward. This
will release the tabs from the printer chassis (Figure 6-8, callout 1).
3 Rotate the tabs 90 degrees, clear of the printer chassis (Figure 6-8, callout 2).
4 Lift the roller out.
Exit Roller Removal
To reinstall
The end of the Exit Roller that has a gear attached must fit into the gear train. It is
possible to reinstall the Exit Roller so that the gear end is on the opposite side of the
printer; this placement would cause paper path problems.
Figure 6-8
6 - 12 Removal and Replacement
To Next Page
Loading...