8. Click Apply to save the information.
9. Repeat steps 1 through 8 for each additional list or destination.
Use the following procedure to test the destination list configuration.
To test the configuration of a destination list
1. Click the Test button (see
Figure 3-4 Alerts screen on page 30) next to the destination list that you
want to test.
The following window appears.
Figure 3-7 Alerts - test screen
2. Select the destinations that you want to test.
3. The return address is the product's e-mail address. Type your e-mail address in the Return
Address box if you would like to receive messages about any errors that are generated from the
test alert (for example, to be notified of an incorrect destination address).
4. If applicable, type additional information that you would like to appear at the beginning of the e-
mail alert message in the Your Notes (optional) text field.
5. Click OK.
34 Chapter 3 Configuring the product from the Settings screens ENWW
To Next Page
Loading...
