ROM disk file operation failed To clear touch “Clear” .................. 243
ROM disk file system is full To clear touch “Clear” ....................... 243
ROM disk is write protected To clear touch “Clear” ..................... 243
ROM disk not initialized To clear touch “Clear” .......................... 243
Size mismatch in Tray <X> ....................................................... 244
Standard bin full Remove all paper from bin ............................... 244
Staple Cartridge low ............................................................... 244
Staple Cartridge very low To continue, touch “OK” ..................... 244
Supplies low ........................................................................... 245
Supplies very low To continue, touch “OK” ................................. 245
Supply memory warning .......................................................... 245
Tray <X> empty: [Size] ............................................................ 245
Tray <X> empty: [Type], [Size] ................................................. 246
Tray <X> open ........................................................................ 246
Tray <X> overfilled Remove excess paper .................................. 246
Tray <X> overfilled To use another tray, touch "Options" ............. 246
Type mismatch Tray <X> .......................................................... 247
Unable to cancel firmware update job ....................................... 247
Unable to install the firmware ................................................... 247
Unsupported drive installed ...................................................... 248
Unsupported supply in use ........................................................ 248
Unsupported supply installed .................................................... 248
Unsupported supply installed To continue, touch “OK” ................. 248
Unsupported tray configuration ................................................. 249
Unsupported USB accessory detected Remove USB accessory ....... 249
Upgrade complete To continue turn off then on ........................... 249
USB accessory needs too much power Remove USB and turn off
then on .................................................................................. 249
USB accessory not functional .................................................... 249
USB hubs are not fully supported Some operations may not work
properly ................................................................................. 250
USB is write protected To clear touch “Clear” ............................. 250
USB not initialized To clear touch “Clear” .................................. 250
USB storage accessory removed Clearing any associated data ..... 250
USB storage device failure To clear touch “Clear” ....................... 250
USB storage file operation failed To clear touch “Clear” .............. 250
USB storage file system is full To clear touch “Clear” ................... 251
Used supply in use .................................................................. 251
Used supply installed To continue, touch “OK” ............................ 251
Warming up scanner ............................................................... 251
Wireless Configuration Mode ................................................... 252
ENWW xiii
To Next Page
Loading...
