Y = fuser mode
◦
0: Photo paper 1, Photo paper 2, Photo paper 3, Designated paper 2, Designated paper 3, or
NA, typed or Autosense
◦
1: Autosense (normal): special case distinguished from typed Normal
◦
2: Normal, typed (not Autosense)
◦
3: Light paper 1, 2, or 3, typed or Autosense
◦
4: Heavy paper 1, typed or Autosense
◦
5: Heavy paper 2, typed or Autosense
◦
6: Heavy paper 3, typed or Autosense
◦
7: Glossy paper 1, typed or Autosense
◦
8: Glossy paper 2, typed or Autosense
◦
9: Glossy paper 3, typed or Autosense
◦
A: Glossy film, typed or Autosense
◦
B: Transparency, typed or Autosense
◦
C: Label
◦
D: Envelope 1, Envelope 2, Envelope 3
◦
E: Rough (designated paper 1), typed or Autosense
◦
F: reserved for future fuser mode
Z = source tray
◦
1: Tray 1
◦
2: Tray 2
◦
3: Tray 3
◦
D: Duplexer
Recommended action
1. To clear message, touch the OK button.
2. If the message reappears, turn the product off and then on.
3. If the error persists, replace the DC controller PCA.
47.FC.YZ Printer calibration failed To continue, touch “OK”
Description
The product is unable to access or implement one of the image pattern files.
ENWW
Tools for troubleshooting
207
To Next Page
Loading...
