Recommended action
Replace the fuser kit.
WARNING! The fuser can be hot while the product is in use.
Replace staple cartridge
Description
The staple cartridge is empty.
Recommended action
Replace the staple cartridge located in the stapler/stacker.
Replace supplies
Description
This alert appears only if the product is configured to stop when a supplies reach the very low
threshold. Two or more supplies have reached the estimated end of life. The product indicates when a
supply level is at its estimated end of life. The actual life remaining might be different than estimated.
The supply does not need to be replaced now unless the print quality is no longer acceptable.
HP recommends that the customer have a replacement supply available to install when print quality is
no longer acceptable.
NOTE: When an HP supply has reached its approximated end of life, the HP Premium Protection
Warranty on that supply ends.
Recorded event codes depend on which supplies are at the end of life.
◦
10.00.70 (event code): Black toner cartridge
◦
10.23.70 (event code): Fuser kit
◦
10.22.70 (event code): Transfer kit
Recommended action
◦
Touch the OK button to find out which supplies need to be replaced.
◦
Configure the product to continue printing by using the Manage Supplies menu.
Roller cleaning is recommended
Description
The product has reached the roller cleaning low count. Clean the ADF rollers to maintain image quality.
242 Chapter 2 Solve problems ENWW
To Next Page
Loading...
