Load Tray 2 and the 550-sheet trays
Introduction
The following information describes how to load paper into Tray 2 and the optional 550-sheet trays. These trays
hold up to 550 sheets of 75 g/m
2
(20 lb) paper.
NOTE: The procedure to load paper for the 550-sheet trays is the same as for Tray 2. Only Tray 2 is shown
here.
1. Open the tray.
NOTE: Do not open this tray while it is in use.
2. Adjust the paper-length and paper-width guides by
squeezing the blue adjustment latches and sliding
the guides to the size of the paper being used.
3. Load paper into the tray. Check the paper to verify
the guides touch the stack, but do not bend it. For
information about how to orient the paper, see
Table 2-2 Tray 2 and the 550-sheet trays paper
orientation on page 27.
NOTE: To prevent jams, do not overll the tray.
Be sure that the top of the stack is below the tray
full indicator.
NOTE: If the tray is not adjusted correctly, an
error message might appear during printing or the
paper might jam.
26 Chapter 2 Paper trays ENWW
To Next Page
Loading...