Load paper to Tray 1 (multipurpose tray)
Introduction
The following information describes how to load paper in Tray 1.This tray holds up to 100 sheets of 75 g/m
2
(20 lb) paper.
NOTE: Select the correct paper type in the print driver before printing..
CAUTION: To avoid jams, never add or remove paper from Tray 1 during printing.
1. Grasp the handle on either side of Tray 1, and pull
it f
orward to open it.
2. Pull out the tray extension to support the paper.
3. Spread the paper guides to the correct size, and
then l
oad paper in the tray. For information about
how to orient the paper, see
Tray 1 paper
orientation on page 19.
Make sure that the paper ts under the ll line on
the p
aper guides.
NOTE: The maximum stack height is 10 mm
(0.4 in), or appro
ximately 100 sheets of 75g
paper.
4. Adjust the side guides so that they lightly touch
the p
aper stack, but do not bend it.
18 Chapter 2 Paper trays ENWW
To Next Page
Loading...