HP LaserJet Enterprise MFP M527dn - Page 31

Tray 1 paper orientation
When using paper that requires a specic orientation, load it according to the information in the following
table.
NOTE: The Alternative Letterhead Mode settings aects the way to load letterhead or preprinted paper. This
setting is disabled by default. When using this mode, load paper as for automatic duplex printing. For more
information, see Use alternative letterhead mode on page 19.
Paper type Single-sided printing Duplex printing and Alternative Letterhead
Mode
Letterhead, preprinted, or prepunched Face-up
Top edge leading into the printer
Face-down
Bottom edge leading into the printer
Use alternative letterhead mode
Use the Alternative Letterhead Mode feature to load letterhead or preprinted paper into the tray the same
wa
y for all jobs, whether printing to one side of the sheet of paper or to both sides. When using this mode,
load paper as for automatic duplex printing.
To use the feature, enable it by using the printer control-panel menus.
Enable Alternative Letterhead Mode by using the printer control-panel menus
1. From the Home screen on the printer control panel, swipe from right to left until the Settings menu
dis
plays. Touch the Settings icon to open the menu.
2. Open the fol
lowing menus:
●
Manage Trays
●
Alternative Letterhead Mode
3. Select Enabled, and then touch the Save button or press the OK button.
ENWW Load paper to Tray 1 (multipurpose tray) 19