Load paper to Tray 1 (multipurpose tray)
Introduction
The following information describes how to load paper into Tray 1. This tray holds up to 100 sheets of 75
g/m
2
(20 lb) paper or 10 envelopes.
NOTE: Select the correct paper type in the print driver before printing..
NOTE: Tray 1 does not support labels. To print on sheets of labels, use Tray 2, or one of the optional 550-
sheet paper feeder
s.
CAUTION: To avoid jams, never add or remove paper from Tray 1 during printing.
1. Open Tray 1.
2. Pull out the tray extension to support the paper.
18 Chapter 2 Paper trays ENWW