Scanner assembly
NOTE: Your product might not appear exactly as the one shown in the photos in this chapter. For
example, the color of the external panels and covers might be different than your product. However, this
does not affect the validity of the procedures in this chapter.
Link assemblies and scanner support-frame spring
1. Push the print-cartridge access button and raise the scanner assembly until it is locked open.
2. Use a small flat-blade screwdriver to release the link tabs on each link assembly.
WARNING! When the link assemblies are disengaged, the scanner assembly can easily fall off
of the product base if it is rotated too far towards the back of the product.
CAUTION: Do not push too hard on the link tabs or the tabs might break.
Figure 5-3 Remove the link assemblies and scanner support-frame spring (1 of 4)
ENWW Scanner assembly 53
To Next Page
Loading...