After performing service
●
Return media to the input tray.
●
Plug in the power cable.
●
Reinstall the print cartridge.
●
Reinstall the trays and output bins.
●
Reinstall the handset.
Post-service tests
After service has been completed, the following tests can be used to verify that the repair or replacement
was successful.
Test 1 (print-quality test)
1. Verify that you have completed the necessary reassembly steps.
2. Ensure that the input tray contains clean, unmarked paper.
3. Attach the power cord, and then turn on the product.
4. Verify that the expected start-up sounds occur.
5. Perform a control-panel test from the secondary service menu. Verify that the control-panel buttons
beep when they are pressed.
NOTE: If the control-panel buttons do not beep, verify that the user did not disable this function.
6. Print a configuration page, and then verify that the expected printing sounds occur. See Information
pages on page 26.
7. Print a demo page, and then verify that the print quality is as expected. See
Information pages
on page 26.
8. If necessary, restore any customer-specified settings.
9. Clean the outside of the product with a damp cloth.
Test 2 (copy-quality test)
1. Verify that you have completed the necessary reassembly steps.
2. Ensure that the input tray contains clean, unmarked paper.
3. Attach the power cord, and then turn on the product.
4. Verify that the expected start-up sounds occur.
5. Print a configuration page, and then verify that the expected printing sounds occur. See
Information
pages on page 26.
6. Place the configuration page in the ADF.
ENWW Service approach 69
To Next Page
Loading...
