Control panel message Description Recommended action
verify that it is seated properly, and then turn
on the product.
If a surge protector is being used, remove it.
Plug the product directly into the wall socket.
Use the power switch to turn the product on.
If the error persists, contact HP. See
www.hp.com/support/ljm1522 or the support
flyer that came in the product box.
Scanner error #, Turn off then on The product has experienced an error in the
scanner sub-assembly area.
Turn off the power by using the power switch,
wait at least 30 seconds, and then turn on the
power and wait for the product to initialize.
If a surge protector is being used, remove it.
Plug the product directly into the wall socket.
Use the power switch to turn the product on.
If the error persists, contact HP. See
www.hp.com/support/ljm1522 or the support
flyer that came in the product box.
Table 12-2 Critical error messages (continued)
ENWW Control-panel messages 169
To Next Page
Loading...