Memory-tag-reader assembly (E-label reader)
1. Remove the following components.
●
Right cover. See
Right cover on page 100.
●
Left cover. See
Left cover on page 102.
●
Rear cover. See
Rear cover on page 106.
●
Scanner/ADF assembly. See
Scanner/ADF assembly on page 117.
●
Top cover. See
Top cover on page 108.
2. Remove the fan from the product chassis (see step 3 of
Fan on page 141).
3. Remove one cable (callout 1) from the cable holder on top of the memory-tag-reader cover.
4. Disconnect one cable from the formatter (callout 2).
Figure 5-61 Remove the memory-tag-reader assembly (1 of 2)
1
2
5. Remove all of the wire harnesses (callout 3) from the retainers.
NOTE: Examine the cable routing as you remove the wire harnesses.
ENWW Internal assemblies 139
To Next Page
Loading...