6. Remove one screw (callout 4).
TIP: When you reinstall the memory-tag-reader assembly, make sure that the front of the
assembly is under the laser/scanner shutter (callout 5).
Figure 5-62 Remove the memory-tag-reader assembly (2 of 2)
4
5
3
7. Lift up slightly the back of the memory-tag-reader assembly, and then slide the assembly toward
the back of the product to release it from the laser/scanner plate.
TIP: The spring is not attached to the memory-tag-reader assembly (callout 6). Do not lose this
spring.
Figure 5-63 Memory-tag-reader assembly spring
6
140 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...