HP LaserJet M2727 MFP Series - Page 163

Duplex solenoid
1. Remove the following components.
●
Right cover. See
Right cover on page 100.
●
Left cover. See
Left cover on page 102.
●
Rear cover. See
Rear cover on page 106.
●
Scanner/ADF assembly. See
Scanner/ADF assembly on page 117.
●
Top cover. See
Top cover on page 108.
●
Convenience-stapler power supply (HP LaserJet M2727nfs only). See
Convenience-stapler
power supply (HP LaserJet M2727nfs only) on page 124.
●
Convenience-stapler bracket and strap (HP LaserJet M2727nfs only). See
Convenience-
stapler power supply bracket and strap (HP LaserJet M2727nfs only) on page 127.
●
Fan. See
Fan on page 141.
●
Duplex-drive gears. See
Duplex-drive gears on page 143.
2. Disconnect one connector (callout 1; J211) at the ECU. Feed the wire harness out of the product
and wire-harness guides.
Figure 5-68 Remove the duplex solenoid (1 of 2)
1
ENWW Internal assemblies 145