HP LaserJet M2727 MFP Series - Page 165

Fuser
1. Remove the following components.
●
Right cover. See
Right cover on page 100.
●
Left cover. See
Left cover on page 102.
●
Rear cover. See
Rear cover on page 106.
●
Scanner/ADF assembly. See
Scanner/ADF assembly on page 117.
●
Top cover. See
Top cover on page 108.
●
Convenience-stapler power supply (HP LaserJet M2727nfs only). See
Convenience-stapler
power supply (HP LaserJet M2727nfs only) on page 124.
●
Convenience-stapler bracket and strap (HP LaserJet M2727nfs only). See
Convenience-
stapler power supply bracket and strap (HP LaserJet M2727nfs only) on page 127.
●
Power-switch PCA. See
Power-switch PCA on page 130.
●
Formatter. See
Formatter on page 132.
●
Duplex assembly. See
Duplex assembly on page 135.
●
Fan. See
Fan on page 141.
●
Duplex-drive gears. See
Duplex-drive gears on page 143.
●
Duplex solenoid. See
Duplex solenoid on page 145.
2. On the right side of the product, press the tabs on two gears (callout 1) to release the gears, and
then slide the gears off of the shafts.
Figure 5-70 Remove the fuser (1 of 9)
1
ENWW Internal assemblies 147