5. Disconnect four connectors (callout 5).
Figure 5-73 Remove the fuser (4 of 9)
5
6. Remove one screw (callout 8) on the wire guide that contains the optional tray 3 connector.
NOTE: It is not necessary to remove the tray 3 connector or the wire harness guide. But you need
to release the guide so that the tray 3 connector wire harness is loose enough to be removed from
a guide on the fuser later in this procedure.
Figure 5-74 Remove the fuser (5 of 9)
8
ENWW Internal assemblies 149
To Next Page
Loading...