Control panel message Description Recommended action
Plug the product phone cord into a jack for
another phone line, and then try sending the
fax again.
Try a different phone cord.
If the error persists, contact HP. See
www.hp.com/support/LJM2727 or the
support flyer that came in the product box.
Fax is busy Redial pending The fax line to which you were sending a fax
was busy. The product automatically redials
the busy number.
Allow the product to retry sending the fax.
Call the recipient to ensure that the fax
machine is on and ready.
Check that you are dialing the correct fax
number.
Check for a dial tone on the phone line by
pressing Start Fax.
Make sure that the phone is working by
disconnecting the product, plugging in a
telephone to the phone line, and making a
voice call.
Plug the product phone cord into a jack for
another phone line, and try sending the fax
again.
Try a different phone cord.
If the error persists, contact HP. See
www.hp.com/support/LJM2727 or the
support flyer that came in the product box.
Fax memory full Canceling recv. During the fax transmission, the product ran
out of memory. Only the pages that fit into
memory will be printed.
Print all of the faxes, and then have the
sender resend the fax. Have the sender
divide the fax job into multiple jobs before
resending. Cancel all fax jobs or clear the
faxes from memory.
Note: Adding a memory DIMM does not help
resolve this issue.
Fax memory full Canceling send During the fax job, the memory filled. All
pages of the fax have to be in memory for a
fax job to work correctly. Only the pages that
fit into memory were sent.
Print all received faxes or wait until all
pending faxes are sent.
Ask the sender to send the fax again.
Cancel all fax jobs or clear the faxes from
memory.
Fax recv. error An error occurred while trying to receive a fax. Ask the sender to resend the fax.
Try faxing back to the sender or another fax
machine.
Check for a dial tone on the phone line by
pressing Start Fax.
Check that the telephone cord is securely
connected by unplugging and replugging the
cord.
Table 6-2 Alert and warning messages (continued)
ENWW Control-panel messages 173
To Next Page
Loading...