8. Lower the green lever.
9. Reinstall the cleanout part by inserting it as shown. Push down on the two tabs until the part snaps
into place. Install the cleanout part correctly, because future jamming might occur if the cleanout
part is not replaced correctly.
10. Close the ADF lid.
Clear jams from the input-tray areas
CAUTION: Do not use sharp objects, such as tweezers or needle-nose pliers, to remove jams.
Damages caused by sharp objects are not covered by the warranty.
When removing jammed media, pull the jammed media straight away from the product. Pulling jammed
media out of the product at an angle can damage the product.
NOTE: Depending on where the jam is located, some of the following steps might not be necessary.
1. Open the rear output door.
182 Chapter 6 Solve problems ENWW
To Next Page
Loading...