Rear (face-up) output bin
CAUTION: Do not use sharp objects, such as tweezers or needle-nose pliers, to remove jams.
Damages caused by sharp objects are not covered by the warranty.
1. Open the straight-through output door.
2. Rotate the green pressure-release levers downward.
3. With both hands, grasp the side of the media that is most visible (this includes the middle), and
carefully pull it free from the printer.
NOTE: If you cannot grasp the media with your hands, perform the procedure in Clear jams from
the print-cartridge area on page 188.
4. Close the straight-through output door.
ENWW Clear jams 187
To Next Page
Loading...