Table 6-10 Service menu
Menu item Sub-menu item Description
Print T.30 trace Never
If error
At end of call
Now
Prints or schedules a report that is used to problem solve fax
transmission issues.
Cleaning mode Cleans the product when specks or other marks appear on printed
output. The cleaning process removes dust and excess toner from
the paper path.
When selected, the product prompts you to load plain Letter or A4
paper in tray 1. Press OK to begin the cleaning process. Wait until
the process completes. Discard the page that prints.
USB speed High
Full
Sets the USB speed.
Less paper curl
Control-panel secondary menus
Use the Secondary service and Developer's menus to perform various tests and print service reports.
Use the control-panel secondary menus
To gain access to the control-panel secondary menus, use the following steps.
1. Press Setup.
2. Press the Left arrow (<) and Cancel buttons at the same time.
NOTE: Some control panels might require that the Left arrow (<) be pressed slightly before the
Cancel button.
3. Press Setup.
4. Use the arrow buttons to navigate the listings.
5. Press OK to select the appropriate option, or Press Cancel to cancel an action or return to the
Ready state.
Control-panel secondary menus
These menus are available from the control-panel secondary menu:
●
Use the Secondary service menu to print service reports, calibrate the scanner, reset the telecom
country/region location, test the control-panel display, and view the firmware version.
●
Use the Developer's menu to test telecom settings, enter scanner settings, adjust fax data-store
parameters, and print developer's reports.
ENWW Control-panel menus 199
To Next Page
Loading...