To adjust fax data-store parameters
When you adjust fax data-store parameters, the product does not alert you to incorrect input values.
Changing fax data-store parameters and render the product illegal or inoperable.
1. On the developer's menu, use the arrow buttons to navigate to R/W Parameter, and then press
OK.
2. Use the arrow buttons to locate the parameter that you want to change. The current setting appears
on the control-panel display.
3. Type the new value for the fax data-store parameter, and then press OK.
To print a list of all the Fax data-store parameters
1. From the developer's menu select Dev. Reports.
2. Use the arrow buttons to select DS Fax, and then press OK.
To change the telecom country/region setting
Three situation can occur that necessitate changing the country/region settings for the product.
●
The customer has moved to a different country/region from where the product was purchased.
●
The information has been erased because of a NVRAM initialization, or parameters are set to “undefined.”
●
The formatter was replaced.
1. On the developer's menu, use the arrow buttons to navigate to R/W Parameter, and then press
OK.
2. Press 3.
3. When the message LIU COUNTRY appears on the control-panel display, press OK.
4. Type the new telecom country/region number, and then press OK
5. After the product returns to the Ready state, turn the power off, and then on.
Table 6-11 Secondary service menu
Menu item Sub-menu item Sub-menu item
Service Reports Cont. Self-Test Cont. Self-Test [Cancel] to stop
Extended Keymap
Error Report
200 Chapter 6 Solve problems ENWW
To Next Page
Loading...