5. Insert the left side of the pickup-roller shaft into the left slot (callout 1), and then insert the right side
of the shaft (the side with the notch) into the right slot (callout 2).
Figure 3-20 Clean the tray 2 pickup roller (4 of 6)
6. Rotate the roller shaft until the notch engages with the drive shaft and clicks into place.
7. Place the left retaining collar over the end of the roller shaft, align the tab on the collar with the slot
in the plastic bracket, and then slide the collar toward the pickup roller.
Figure 3-21 Clean the tray 2 pickup roller (5 of 6)
ENWW Clean the product 53
To Next Page
Loading...