8. With the tab on the right collar aligned with the slot on the plastic bracket, slide the collar towards
the pickup roller. Rotate the right and left retaining collars down into the locked position.
Figure 3-22 Clean the tray 2 pickup roller (6 of 6)
9. Push up on the duplex assembly until it locks into place, and then place the product upright on the
work surface with the top of the product facing up.
WARNING! When you move the product into this position, the scanner cover can open suddenly
and be damaged. You must support the scanner cover to keep it from opening.
10. Perform the following tasks after completing this procedure.
●
Replace the product on tray 3, if that tray was installed.
●
Replace the tray 2 cassette.
●
Open the print-cartridge door and install the print cartridge.
●
Plug the power cord into an electrical outlet, and turn on the product.
54 Chapter 3 Maintenance ENWW
To Next Page
Loading...