8
Windows
To install a USB connection, go to step 20. Windows with a direct connection (USB). 20) Install the software from the CD
before connecting the cable to the device. Note: If the New Hardware Found
message appears, insert the CD. Follow the onscreen instructions, accept the default
selections, and then go to step 31 on page 10.
21) On the welcome screen, click Install Printer. The Setup Wizard appears.
Note: If the welcome screen does not appear, click Start, and then click Run. Type
X:SETUP (replace X with CD-ROM drive letter), and click OK.
22) Follow the onscreen instructions. When prompted, connect a USB cable between
the device and the computer. Note: HP does not recommend using USB hubs. Use a
USB cable that is no longer than 2 meters (6.5 feet).
To Next Page
Loading...